DynaSense MK III
Digital, Universal Temperature Control
Features:
- Thermocouple or RTD Input
- Heat/Cool Control Action
- User Programmable: Proportional or On/Off Control
- 4 Digit PT/ST Display
- 5 State PT Deviation Readout
- Accuracy: ± 0.25% Full Scale
- Sensor Input (order separately):
Thermocouple (T/C) Type T, J, E, K
Platinum RTD 100 ohms - 20 Different Ranges Varying From -130°F to +1800°F or -90°C to +1200°C
- 1200W Load Capacity
(higher power loads possible with optional Load Power Center I)
- LED 4-digit Display: Allows instant user choice of Process Temp (PT) or Set Temp (ST) by manual switch selection or exclusive automatic alternative action solid state switching of PT/ST display.
- Hysteresis Control: Allows adjustment of the control system cycle rate and on/off hysteresis, which is adjustable from 0.25% to 10% of full scale to maximum of 10°F.
- Bandwidth Control: Proportional models are adjustable from 0.5% to 20% of chosen full scale span.
- Power Output: Relay has conservative 10AMP heating and 10AMP cooling load. Higher power loads possible with optional Load Power Center I. Call us for higher power options.
- Setpoint Control: Exclusive circuit allows setpoint adjustment by 1 degree increments, or .1 degree increments in the high resolution mode.
- Deviation Indicator: Exclusive 5-state LED logic device provides selectable resolution of process deviation from set temp to 1%, 2%, or 4% of full scale.
- Recorder Output and Audible Alarm Options: Various options are available - call us directly for these options.
- Plug and Play Ready: Just plug in the probe and heater and you are ready to control your process.
The DynaSense® MK III is a universal digital proportional or on/off temperature control which allows instant system setup. These controllers provide pinpoint accuracy of heating and cooling devices through the use of two position, on/off control action, operating alternately and independently with true proportional cooling algorithms. The temperature change of the input sensing devices is analyzed by an 8-bit microprocessor which controls a high current, electromechanical, two position relay in direct relation to system demand and deviation from the temperature setpoint. Typical control accuracy is ± 0.02°F. Indicating accuracy is ±0.25% full scale, ±1 digit.
MK III Temperature Controllers
| Control Type |
Sensors | |||||
|---|---|---|---|---|---|---|
| T | RTD | J | E | K | ||
| -90 - 250°C -130 - 500°F |
-90 - 400°C -130 - 750°F |
0 - 800°C 32 - 1400°F |
0 - 600°C 32 - 1100°F |
0 - 1200°C 32 - 1950°F |
||
| On/Off Control |
°C | 221-040 $743.00  |
221-041 $743.00 |
221-042 $743.00 |
221-043 $743.00 |
221-044 $743.00 |
| °F | 221-045 $743.00 |
221-046 $743.00 |
221-047 $743.00 |
221-048 $743.00 |
221-049 $743.00 |
|
Sensor Notes
| T | Copper/Constantan |
| RTD | Platinum Wire |
| J | Iron/Constantan |
| E | Chrome/Constantan |
| K | Chrome/Alumel |
Printer-Friendly Version